Cisco DNA Center SecondGeneration Appliance Installation Guide
Posted on by
Cisco Vsl Config. Integrate Cisco Service Modules with Catalyst 6500 VSS 1440 Cisco The following VSL configuration commands are not removed from the interface when it becomes restricted: † mls qos trust cos Configuring VSL properly is essential for proper VSS functioning
Cisco Prime Infrastructure 3.1.3 User Guide Using Converged Access from www.cisco.com
This means that only specific configuration commands can be configured on the interface I would like to setup it by using stackwise virtual technology
Cisco Prime Infrastructure 3.1.3 User Guide Using Converged Access
SW1 (config) #interface port-channel 1 SW1 (config-if) #no shutdown SW1 (config-if) #switch virtual link 1 SW1 (config-if) #exit SW1 (config) #int ten 1/4 this older VSS post from Netpro where someone had configured Switch 1 to use Po 10 and Switch 2 to use Po 25 on the VSL links SW2(config)#switch virtual domain 10 Domain ID 10 config will take effect only after the exec command 'switch convert mode virtual' is issued SW2(config-vs-domain)#switch 2 SW2(config-vs-domain)#exit SW2(config)# STEP2: Configuring VSL Port Channel
How to Configure Cisco Router Interfaces and Serial. Then after the configuring the virtual switch ID and domain, the port-channel numbers are changed on the two switches. Configuring VSL properly is essential for proper VSS functioning
Cisco Configuration Professional Quick Start Guide Cisco. When an interface is in restricted mode, only specific configuration commands can be configured on the interface During VSL link configuration, a 10gig port on each Switch was used